How to plaster a wall on beacons

You will need
  • - perforator;
  • - nails;
  • - dowels;
  • - construction cord;
  • - Plumb;
  • - a piece of wire;
  • - marker;
  • - plaster;
  • - rule;
  • - trowel
Instruction
Mark the wall. To do this, it is necessary to drill a hole in the upper corner of the wall, located at a distance of 15-30 cm from the ceiling and the adjacent wall. Drill a symmetrical hole in the second upper corner. Drive in the wooden dowels and secure the nails. Nails must be driven in so that they protrude from the surface of the wall by 6-8 cm.
Take the cord and make loops on its ends so that it can be taut tight between the installed nails. These loops should allow the cord to move along the nails, removing or bringing it closer to the wall, depending on the need.
Take a piece of hard wire and make an S-shaped hook out of it. Attach one side of the hook to the cord so that the hook can mix freely.
Plumb a necessary length so that it is located at a height of 5-7 cm from the floor level. Attach the plumb line to the second side of the hook.
Moving the plumb line along the cord, determine the most prominent place on the wall surface. After that, you need to move the plumb line along the cord to the end, to one of the walls.
Drill a hole and hammer a nail into it so that it touches the hanging plumb line from the side. Make a mark on the nail, at the point of contact of the plumb line.
Tension the cord between the upper and lower nails. Do the same on the opposite side of the wall. Stretch the cord between the bottom nails. In the end, you should have a rectangle of stretched cords.
Put stamps. To do this, apply the plaster on the wall at a distance of 3-5 mm from the nail head. Allow the mortar to dry and carefully cut it so that the surface of the mark is parallel to the wall level, flush with the nail head. Carefully check the position of the marks using the building level.
Prepare plaster mortar. Apply a layer of plaster between marks so that it protrudes slightly over their surface.Stick a rule to the stamps and, moving it down and up, align the wall surface with the stamps. Make sure that the plaster does not fall on the surface of the lighthouses.
Wait for the solution to dry and apply a putty finish.


Related News


How to cook Tatar meat pies
With such a haircut you will always be the focus of attention The best haircuts for medium hair 2017
What is a crankcase
Miniature Gift Box
Neuleptil: instructions for use, indications, price
Mini Poster Tags
E-book cover from the book