Pencil Scroll

To teach the child to order and make the drawing process more fun, sew a bright pencil case for the little artist. It is convenient because in the process of drawing the child does not need to pour all the accessories out of the box: it is enough to unfold the scroll and all the pencils will be in front of the child. A pocket with dividers will help the child to group pencils or felt-tip pens by color, and the valve will not allow them to fall out during storage or transportation. Materials. From the materials you will need two cuts of companion cotton fabrics (in this case, yellow and green), flizelin, sintepon, satin or rep ribbon, pendant, wooden buttons and threads in the color of the fabric.
 Materials

Preparation of parts. According to the scheme, cut out from yellow fabric and polka dot fabric one rectangle 25x32 cm in size.
 According to the cut scheme
The yellow rectangle will act as a cover,and green - the basics for the valve and pocket.
 bases for the valve and pocket
To make the latter from green fabric, cut a rectangle of size 30x34 cm and bend it in length on the front side. This will result in a 15x34 cm billet for a pocket. For a valve, cut a 16x32 cm rectangle, then fold it along the inner side and, 1.5 cm apart from each edge, cut the corners.
cut the corners
The result is an equilateral trapezoid with bases 32 and 29 cm long and 8 cm high. Assembling parts. Take a ribbon 32 cm long and sew it to the cover details.
 sew it to the cover details
Stretch the pocket detail from the inside out with non-woven fabric, fold it along the fold line and lay a longitudinal decorative seam.
 lay the longitudinal decorative seam
Take the valve part and lay along the sides and on the short base of the trapezoid straight line (a).
 valve part
Then turn out the part,iron it and again along the same sides lay a line, but already decorative (b). The upper base can not be closed, because at the final stage of assembly two fixing seams will pass through it. Tailor's pins pin a pocket detail to the base detail (green rectangle).
 pin a pocket detail
According to the diagram, the length of the pocket detail was 34 cm, and the basics - 32 cm. A difference of 2 cm is necessary to create volume for sections under pencils. Therefore, securing the pocket on the base, first trim the edges of both parts, and then evenly distribute the fabric. Now make cells for pencils. To do this, lay the straight seams across the width of the pocket with an interval of 1-1.6 cm. At the beginning and at the end of the lines, be sure to make locks (a seam of 0.7-0.9 cm in the reverse mode of the sewing machine). Pin the valve detail to the base.
 Pin the valve detail to the base
Make ties from the fabric. To do this, cut a rectangle with a length of 55 and a width of 4 cm. Fold it in the middle of the widow and bend to the fold line of the edge. Lay a straight or decorative stitch around the edge.You can also use a cord, ribbon or knitted chain as ties. Sew strings to one of the short sides of the base.
 Sew stitches
Strengthen the cover from the inside with non-woven fabric or ironed padding. Cover the part with the pocket and flap cover detail, aligning the edges of all the details. Make sure that the front sides of both blanks are inside. Lay a straight line around the perimeter of the canister-scroll, leaving an inversion hole on one of the short sides.
 turning hole
Turn out and steam the case, and the edges of the hole Press inside.
press inside
It remains only to lay a decorative line around the perimeter of the canister-scroll and put a car in it Andashi.


Related News


Paper Flower
Gifts handmade to women, girls, girls
Chocolate Coffee Card
Burnt Wood Cutting Board
A simple DIY hanger
Wedding Dress Models
Stained glass painting with a bouquet of flowers
Bags for storing herbs and seeds